|
SC CARBON BLOCK CARTRIDGE
APPLICATIONS
Our SC CARBON BLOCK CARTRIDGE are used where the customer is seeking a consistent, cost efficient, long life filter with low change-out frequency.
These include:
- Residential and commercial water treatment.
- Pre-RO
- Pre-filtration for DI water
- Fine Chemicals, reagents, solvents, resins
- Coatings
- Edible oils,
- Liquors, juices, sugars
- Make-up water
Test Report
Result:
Initial
△P (psi) @ Flow Rate (gpm): 3.0 psi @ 1 gpm (0.23 bar @ 3.8 L/min) |
Chlorine Taste & Odor Reduction @ Flow Rate (gpm): >3,000 gallons @ 1 gpm
(11,350 liters @ 3.8 L/min) |
Specifications
Highest Operation Temperature |
82
℃ or 180
℉ |
Material |
activated carbon |
| Maximum operation pressure difference |
60℃ 1.8kg/cm2
20℃ 2.2kg/cm2
|
| Suggestive pressure difference changes at |
1.5kg/cm2 |
Order Information
| ORDER INFORMATION |
SERIES |
SURFACE |
MICRON |
LENGTH |
OD |
GASKET |
SC |
-CO |
-5 |
-10B |
-2.75 |
-B |
SC: SINO-FILTER
CARBON BLOCK CARTRIDGE
|
CA:COAL BASED |
MICRON RATING: 1,5,10UM
|
10A=
248MM |
2.75=70MM |
B: BUNA-N |
CN:COCONUT BASED CARBON |
10B=
250MM |
4.5=115MM |
V:VITON |
|
20=508MM |
|
E:EPDM |
30=762MM |
|
|
40=1016MM |
|
|
50=1270MM |
|
|
Attentions:
1. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
2.Our SC carbon block cartridges will contain a very small amount of carbon fines (very fine black powder) and a new cartridge after installation should be flushed with sufficient water to remove all traces of the fines from your water system before using the water. Each time you use your filtered water tap for drinking or cooking purposes it is recommended that you run (flush) the tap for at least 20 seconds prior to using water.
3.our SC carbon block filter can be used for whole filter housing, water purifier or reverse osmosis filter systems.
|
